If you would like to test your website to see if number replacement is working do the following. When visiting a website with Mongoose code installed a cookie will be placed on your computer, it will last for 12 Hrs. Please delete cookies on your computer before performing the test, secondly you must wait 2 minutes between tests for accurate results.
Click on Setup Instructions for the campaign you want to perform the test on
*Note: This option is only available for session campaigns (SPC), if you have a Dynamic 1:1 campaign please use the manual method mentioned below.
Scroll down the page until you get to Step 2. You have two options available for checking the code on your site.
1) Use the built in Test Your Session Campaign method, for this method you simply need to enter the URL of your website where the code is installed then click on the "Test Your Session Campaign" button.
If the code is installed properly and number replacement is working you will receive the following confirmation.
Test your code and number replacement manually
Manually verify your installation is working. Copy the below line of text to the end of your URL that is running the Mongoose Metrics SPC or Dynamic 1:1 code, you will need to put in your campaign code where it says Enter_Campaign_Code_Here.
Locating your campaign codeClick on Edit Campaign
Your campaign code will be listed near the top middle section of the page. You can copy and paste into the section of code above replacing Enter_Campaign_Code_Here